Ron Kropp

I was able to balance out my fan at the highest speed, but then at the slowest speed the fan still wobbled (no loose blades, bearings, accessories). The fan is mounted about 1.5 ft below a slanted ceiling, so there could be some chaotic turbulence issues. Unfortunately, this app requires the fan to run at higher speeds to properly detect. When I tried to balance the fan at a slow speed, the app repeatedly reported blade detect problems, or it crashed.

Mustafa Motiwala

I've had a huge wobble in my fan for years that create an annoying noise. trying to balance manually has not been helping. tried the app. it took several trys but I finally got my wobble from the 40s to around 5. so yes this app really works!! only issue I had with app is getting to detect the black dot. make sure the dot is a white background and smaller than a dime. place phone 3ft away. too close and u get bad readings too.

Taylor Pearcy

Didn't work... App just says "Something Went Wrong" at the end of the process and I don't know what to do from here. Also instructions regarding the "clips" are not clear. Do you need 1 clip per blade and then supposed to add a clip to each blade as you progress OR or are you supposed to just move ONE clip from one blade to another. Anyway, I tried it both ways and got the same result... Edited

Jeremy Grabowsky

works well but could use some additional tips. here's what I found to work the best while using this app. 1. just use a dime colored black instead of drawing a dot. I also used white masking tape to increase the contrast of the dime. 2. try balancing on medium rather than high. my fan balanced out pretty well on high, but the wobble persisted at medium. 3. use a steady table or ladder rung to get the 2' from ceiling fan required.

Nathan McCorkle

I really wanted this to work. It feels like it would be the right approach to balance my fan. I had a platform ladder and a camera tripod, so I thought I'd be prepared for smooth sailing. Unfortunately for me, I have an exposed beam in my ceiling directly above where the fan is, and it seemed to confuse the algorithm. Somehow I managed to get through the process and I wasn't confident of the results, but was unable to complete a second round. Just found devs email addr, will update review later. Edited